This title appears in the Scientific Report :
2005
Please use the identifier:
http://dx.doi.org/10.1016/j.jpowsour.2005.02.014 in citations.
Residual Stresses in Planar Solid Oxide Fuel Cells
Residual Stresses in Planar Solid Oxide Fuel Cells
The in-plane residual stress distribution in the electrolyte of an anode-supported planar solid oxide fuel cell has been determined using X-ray powder diffraction. Measurements have been carried out with half cells in green state, after co-firing and after anode reduction. The residual stress in the...
Saved in:
Personal Name(s): | Fischer, E. V. |
---|---|
Malzbender, J. / Blass, G. / Steinbrech, R. W. | |
Contributing Institute: |
Werkstoffstruktur und Eigenschaften; IWV-2 Werkstoffsynthese und Herstellungsverfahren; IWV-1 |
Published in: | Journal of power sources, 150 (2005) S. 73 - 77 |
Imprint: |
New York, NY [u.a.]
Elsevier
2005
|
Physical Description: |
73 - 77 |
DOI: |
10.1016/j.jpowsour.2005.02.014 |
Document Type: |
Journal Article |
Research Program: |
Brennstoffzelle |
Series Title: |
Journal of Power Sources
150 |
Subject (ZB): | |
Publikationsportal JuSER |
The in-plane residual stress distribution in the electrolyte of an anode-supported planar solid oxide fuel cell has been determined using X-ray powder diffraction. Measurements have been carried out with half cells in green state, after co-firing and after anode reduction. The residual stress in the electrolyte is compressive. Values of about -560 MPa are determined at room temperature for an approximately 10 mu m thick electrolyte layer on an oxidized similar to 1.5 mm thick anode substrate, independent of location. Chemical reduction of the anode leads to a slight decrease of the compressive electrolyte stress to -520 MPa. At operation temperature (800 degrees C) the stress is by a factor of about two lower, but remains compressive. The electrolyte results are used to calculate the residual stress in the oxidized and in the reduced anode. Independent of the oxidation state a tensile stress of about 4 MPa is calculated. Implications for anode failure are discussed by comparing this value with the fracture stress of large 200 mm x 200 mm cells at a failure probability of 10(-6). (c) 2005 Elsevier B.V. All rights reserved. |